● lnto the collet and replacement of cutting tools,must clen up the thread of nut and ontology,and add grease,otherwise it will cause damage to the screw thread.● Full circle-no eccentric nut design,low noise,small wind resistance,suitable for high speed.
● Selection of steel● Using high-quality 20CrMnti material, carburizing and quenching, high hardness, high toughness, long precision life.● Connect the tool● According to the processing requirements, it can be used with a variety of specifications of locking teeth.● High precision grinding● Hi
● The clamping hole tolerance H5● With less than 20mm a locking screw,with a diameter of 25mm above two locking screw.Features:● BTNO taper shank executives AT3 standard.● Tolerance h5 for d inner bore.● Predict balancing design.
● The handle and the chuck is combined,even for heavy cutting processing,chuck will not fall off.● Fast,easy operation,high safety.Features:● BTNO taper shank executives AT3 standard.
● It is used for clamping the Morse taper at the end cutting internal threads or extension rod.Features:● BTMP taper shank executives AT3 standard.● No more than 0.005mm for the cone concentricity.
● For Morse taper drill tool,tool handling time is short,easy to operate.Features:● BTMP taper shank executives AT3 standard.● No more than 0.005mm for the cone concentricity.
● Collet nut design-no pull, strong stability, and high rigidity.● The recommended torque wrench, Dose not exceed the recommended value of 30%, with high torque, the deformation may lead.
● The design uses 4 Deg collet clamp unilateral, high precision repeat loading.● All-round nut design, low noise, small wind resistance, suitable for high speed.
1、A collet and replacement of cutting tools,screw nut and body must be clean,and add grease,Otherwise it will cause damage to the thread.2、The device must be placed when the collet nut,and then into the tool,then the lock body.